DataCard UltraGrafix Select Installationshandbuch PDF herunterladen (Seite 292)

280 ConCAD

Vector Settings Tab

Vector elements are available for laser templates only. The vector settings tab is

common to all vector-based images.

Vector Mode

Black line Results in a solid, non-tactile line, depending on laser

settings and card material.

Tactile line A tactile vector is a vector that is lased so that the

material actually breaks up. This results in a tactile

surface (when moving your finger over it you can feel

it), depending on laser settings and card material.

Manual Manually enter all settings (see below).

Fill Mode (enabled if Vector Mode is set to “Manual”)

Hatch Hatching is a technology used to automatically

produce vectors of a certain line width. Small vector

lines are produced orthogonal to the vector direction.

Wobble A technique to lase thick vectors. Normally the laser

produces a very thin line. By wobbling, the line can be

made thicker or stronger.

The laser beam rotates along a line in a spiral

movement with a certain amplitude (spiral diameter =

line thickness) and frequency (Wobble Frequency).

No Filling No filling will occur.

Settings

Line Thickness (mm) Line thickness, must be entered manually.

Point Density (dpi) Enabled if Vector Mode is set to “Manual”. DPI values

can range from

0 to 4294967295

Wobble Frequency (Hz) Enabled if Fill Mode is set to “Wobble”. See the

description for “Wobble” above.

Vector Power Enabled if Vector Mode is set to “Manual”. The

selected laser power level for this vector.

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 321 322

Keine Kommentare

DataCard UltraGrafix Select Installationshandbuch Seite 292