DataCard UltraGrafix Select Installationshandbuch PDF herunterladen (Seite 144)

132 Form Setup

When the fold type is not a data field, the checkbox for using default

fold locations is disabled. When the fold type is a data field, the

checkbox for using default fold locations is enabled. If this checkbox is

checked, the fields for typing in custom fold locations become disabled.

If the checkbox is unchecked, the custom fold locations fields will be

enabled. This option is for those who may wish to use non-default fold

locations and are only switching between fold types with the same

number of folds and want to use the same non-default fold locations for

all fold types.

11. Select the location of the fold (or folds, depending on the fold type selected)

by entering the value in the fields. Alternately, you can use the spin controls

to set the value(s).

Notes:

If the value you select is outside the acceptable range, the figure in the

box will be reset to the old value.

You can also control the fold location from the virtual form.

12. If you are using

an MXi and need to configure MXi jobs, refer to “Configuring

MXi in Form Setup” on page 142.

13. C

omplete the setup of the virtual form (refer to the next section).

If you are using nested forms, select 2 from the Number of Forms list and

then repeat steps 3 through 12 on Form 2. (An additional Barcode reader,

mounted in the Card Affixer module, is required for this feature.)

14. Click the Save icon in the toolbar when finished.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 321 322

Keine Kommentare

DataCard UltraGrafix Select Installationshandbuch Seite 144