DataCard ImageCard Select Betriebsanweisung PDF herunterladen (Seite 91)

Install the printer 7-5

User’s Guide for Select™ Platinum Series™ Printers

Figure 7-4: Connect the parallel port cable

2 Attach the other end of the cable to the parallel port on the PC (see Figure 7-4).

Press the cable connector all the way onto the port, and then turn the posts to

secure the cable to the PC.

Some parallel communication devices use a cable with a plug that allows

another device to be attached, so that two parallel devices are attached to

one PC parallel port, known as a pass-through or piggy-back plug. The printer

and printer driver cannot communicate reliably through such a plug. Install an

additional parallel port in the PC if needed.

♦

Connect a USB data cable

The USB cable must be a type CM 30V cable, up to a maximum of 6.5 feet or 2

meters long. A longer cable might result in electrical interference.

1 Attach the flat end of the USB cable to the USB port on the PC (see Figure 7-5) or

to a device attached to the PC through a USB port.

If the printer has two USB ports, the upper USB port should be identified with

a smart card label and pink plug. Do not use the upper USB port; use the USB

port toward the center of the panel.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 154 155

Keine Kommentare

DataCard ImageCard Select Betriebsanweisung Seite 91