DataCard ImageCard Select Betriebsanweisung PDF herunterladen (Seite 23)

Using the printer 2-7

User’s Guide for Select™ Platinum Series™ Printers

6 Make sure print ribbon unwinds over the top of the print ribbon cartridge, not from

the bottom.

♦

Replace the print ribbon cartridge

1 Place the ribbon cartridge onto the ribbon cartridge supports (see Figure 2-9).

Make sure the cartridge is securely seated. Avoid touching the printhead cartridge

and ribbon tracker.

Figure 2-9: Replace the print ribbon cartridge

2 Close the swing arm, pressing it down until the push latch clicks into place.

3 Close the cover.

♦

Powering on the printer and PC

Use the following procedure to power on the printer and attached PC.

Power on the printer and PC

If the printer is connected over a network using a print server, make sure the

driver is installed and configured on the PC before using it.

1 Make sure cards and all other supplies are loaded. See other sections of this

chapter for more information.

2 Remove any printed or rejected cards from the output stacker. See “Removing

cards” on page 2-12 for more information.

3 Make sure the power cord and data cable are connected. If needed, see

“Connecting cables” on page 7-3 for more information.

4 Press the printer Power switch to turn on power. Observe the printer status light

which lights with a sequence of colors and then becomes steady green. See

“Status light” on page 2-9 for more information. The printer initializes components

and makes audible sounds.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 154 155

Keine Kommentare

DataCard ImageCard Select Betriebsanweisung Seite 23