DataCard ImageCard Select Betriebsanweisung PDF herunterladen (Seite 66)

5-4 Troubleshooting

User’s Guide for Select™ Platinum Series™ Printers

Make a printer test card

The Select printer does not need to be connected to a PC to print this card.

1 Power off the Select printer.

2 Confirm that all supplies are loaded. See “Using the printer” on page 2-1 if

needed.

If the printer has a magnetic stripe module, the cards for a printer test card

must have a magnetic stripe. If it is a three-track module, be sure to use the

high coercivity blank cards shipped in the supplies kit.

3 Press and hold the Ready button (1), and then power on the printer (2) as shown

in Figure 5-1. Hold the Ready button until the printer sounds three tones, usually 5

to 10 seconds.

Figure 5-1: Press and hold Ready button (1) and then Press Power switch (2)

4 Release the Ready button. You hear the internal components initialize. Allow 30 to

60 seconds for the printer to begin printing the test card. The status light will flash

green while the printer is processing the data.

5 Remove the card from the card output stacker. A printer test card is shown in

Figure 5-2.

If the printer test card did not print successfully, see if there are problems with the

printer such as jammed cards or an out of ribbon condition.If needed, turn to

“Troubleshooting” on page 5-1.

♦

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 154 155

Keine Kommentare

DataCard ImageCard Select Betriebsanweisung Seite 66