DataCard RL90 Betriebsanweisung PDF herunterladen (Seite 42)

Cleaning the laminator

36 RP90 and RL90 User Guide

Cleaning the laminator

Most card jams are caused by dirty rollers. Clean the laminator at the same

time that you clean the printer. If you are using the laminator as a stand-alone

unit, clean the laminator every 1,000 cards.

Run a cleaning card

1 Press the MENU key on the laminator’s LCD panel until "Cleaning" is

displayed.

2 To clean the transport roller only:

a Press the ENTER key and "Without HR" is displayed.

b Press the ENTER key and "Cleaning OK" is displayed.

c Press the ENTER key and cleaning starts.

3 To clean the transport roller and heat roller:

a Press RESET and then ENTER and "With HR" is displayed.

b Press ENTER and "Film removed?" is displayed.

c Remove the laminator cartridge, remove patch or topcoat material,

replace the empty cartridge into the laminator, and close the

laminator door.

d Press the ENTER key and "Cleaning OK?" is displayed.

e Remove the protective paper

from the cleaning card and

press the ENTER key.

f Slide the cleaning card into

the card discharge slot. The

card will be drawn into the

laminator and will exit from

the same slot when cleaning

is complete.

4 Press the EXIT key twice to exit

the cleaning menu.

5 Reload and initialize the

material.

Tips – Laminator cleaning

card

• When the heat roller is

at operating

temperature, “HR is too

hot” is displayed on the

LCD display. Turn

power OFF and allow

unit to cool for

approximately 30

minutes before starting

the cleaning sequence.

• Use a cleaning card one

time only. Using a dirty

cleaning card can

cause card jams.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 74 75

Kommentare zu diesen Handbüchern

Keine Kommentare

DataCard RL90 Betriebsanweisung Seite 42

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Multifunktionsgeräte DataCard RL90