DataCard ImageCard Select Betriebsanweisung PDF herunterladen (Seite 86)

B-3

User’s Guide for Express™ and Select™ Printers

Card size

Use CR-80 size cards with the following nominal dimensions:

Actual card thickness can vary by up to ten percent from the sizes listed. Smart

card chips can be raised slightly from the printing surface.

Card bow must be less than the thickness of the card.

Figure B-1: Excessive card bow

Card material

Use cards made of the following types of material:

•

Glossy PVC surface, either 100% PVC cards or composite cards with a PVC

surface.

•

Cards with a magnetic stripe on one side of the card.

•

Cards with a smart card chip on the top of the card. Depending on the module

installed in the printer, contact-type, contactless, or both types of smart card chips

can be programmed.

Embossed cards cannot be printed with the Express or Select printer.

New cards preferred

The Express or Select printer is designed to print on new card stock. If you print on

cards twice, be careful to avoid getting dirt, fingerprints, or other contamination on

cards before the second printing. Printing on cards that have been issued might

introduce substances that interfere with card printing or damage the printer. See

“Problems with card appearance” on page 6-2 to address card appearance problems

with pre-printed cards.

Length 3.37 inches 85.60 mm

Width 2.125 inches 53.98 mm

Thickness with

smart card chip

0.020 to 0.030 inches 0.500 to 0.760 mm

Thickness (all

other cards)

0.020 to 0.050 inches 0.500 to 1.27 mm

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 109 110

Keine Kommentare

DataCard ImageCard Select Betriebsanweisung Seite 86