DataCard LM200 Betriebsanweisung PDF herunterladen (Seite 44)

38 SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide

Laminator tab

The Laminator tab is enabled if a laminator is connected to the printer. Use the settings on

this page to adjust lamination for best results. See “Laminator Settings” on page 60 for

examples of settings for single-sided and double-sided lamination.

The Laminator tab shows:

• Basic Settings:

— Laminate Mode: Laminate or Pass

Through.

— Choose Laminate to laminate a card.

— Choose Pass Through to skip

lamination.

— HR Control: Enable or Disable.

— Sets power saving, which reduces the

temperature of the laminator heat roller

after the laminator is not used.

—

This setting works with the card printer

setting, described on page 33. This is

always set to ‘On’ automatically when

overlay film is selected. (The laminator should be put into standby if you will not

be printing cards for a long time.)

— Cleaning Counter: Displays how many laminations have been performed since

the last roller cleaning.

• Bottom and Top Side Settings:

— Cassette Status Display: Displays Cassette Detected or No Cassette.

— Film Type Selection: Patch or Overlay. See “Laminator material” on page 89 for

more information.

— Patch position. See “Patch Position” on page 82 for more information.

— Heat roller temperature setting. Sets the temperature for the laminator heat

roller.

• Common Settings:

— Speed: Sets the card speed during lamination.

— Cooling Time: Sets the standby time for cooling down the card before lamination

starts.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 108 109

Keine Kommentare

DataCard LM200 Betriebsanweisung Seite 44