DataCard LM200 Betriebsanweisung PDF herunterladen (Seite 15)

SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide 9

Remove Hopper and Cards

The card hopper can be removed from the printer for secure storage, to set

card thickness, or for cleaning.

1 Slide the card hopper latch

closed (1).

2 Lift the hopper up (2). The

hopper cover and hopper are

locked together and both are

removed.

Replace the Hopper

1 Insert the hooks on the card hopper

into the slots in the receptacle.

2 Slide the card hopper down until it

clicks into place.

Adjust Card Thickness

From the factory, the printer is set to use cards 0.030 in (0.75mm) thick.

Follow these steps to set the printer to use cards of a different thickness.

1 Remove the card hopper, as described

above.

2 Turn the hopper so the silver dial faces

you.

3 Use a pointed item such as a pen.

Slide the dial:

— Slide the dial counterclockwise

(CCW) to print thinner cards.

— Slide the dial clockwise (CW) to

print thicker cards.

• A setting of 1.0mm corresponds to cards 0.040in thick.

• A setting of 0.75mm corresponds to cards that are 0.030in thick.

• A setting of 0.5mm corresponds to cards that are 0.020in thick.

• A setting of 0.25mm corresponds to card that are 0.010in thick.

4 Replace the Card Hopper, as described above.

5 Set the card thickness on the Status Monitor. See“Media Setting tab”

on page 36.

6 Test the new setting with several cards to make sure the printer picks

only one card at a time.

Tips: Card thickness

• Cards with low heat

resistance, such as PVC

cards, are only supported

for settings of 1.0mm and

0.75mm.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 108 109

Keine Kommentare

DataCard LM200 Betriebsanweisung Seite 15