DataCard LM200 Betriebsanweisung PDF herunterladen (Seite 55)

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 45

Iftheprintercannotrecognizethetypeofinkribbon,oneofthefollowingreasonsisdisplayed:

UsetheMediaSettingtabtovieworchangethetypeandthicknessofcardsbeingused:

1. ForMaterial,selectPVC,PET‐G,orHR‐PET‐G(0.25mm).

Therecommendedvaluesfor

retransferspeedandtemperaturedependontheselectedcard

type.(Referto“RetransferTab”onpage 43.)

2. ForThickness,select:

 Standardforcards0.75mm(0.030inch)thick

 Thinforcards0.25mm(0.010inch)thick

3. UseFilmTypetoselectthetypeofretransferfilmbeingused.

TipsforSuccess

 Printsamplecardstoverifysettingsbeforeusingcardsofadifferentthicknessormaterial

type.

 Printononesideofthincards.Donotprintonbothsides.

 Settheinputhopperforthecardthickness.Ref erto“AdjustingCardThickness”onpage 14.

 ThinPVCcardsarenotsupported.

Display Reasonsforinkrecognitionerror Solutions

252:InvalidTAG

Data

Thedatafortheinkribbonis

incorrect.

Replacetheinkribbonandtry

again.

253:DefectiveTAG Theprinterdidnotrecognizetheprint

ribbondata.

Replacetheinkribbonandtry

again.

254:NoTAG Theprintercouldnot

readtheprint

ribbondata.

Makesurethattheinkribbon

hasbeenloadedcorrectly.Refer

to“LoadinganInkRibbon”on

page 15.

255:Defective

R/W

Theprinterisdefective. Theprintermustberepaired.

Caution: The Thin setting is not recommended for

use with PVC cards.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 137 138

Keine Kommentare

DataCard LM200 Betriebsanweisung Seite 55