DataCard LM200 Installationsanleitung PDF herunterladen (Seite 20)

12 Installing the Hardware Components

Installing the Card Hopper

1. Ifpresent,removestyrofoampackingfoamfrominsidethecardhopper.

2. Insertthecardhopperhooksintothereceptacleslotsontheprinter.

3. Slidethecardhopperdownuntilitclicksintoplace.

Installing the Card Stacker

Ascompletedcardsexittheprinterorlaminator,theyarecollectedinthecardstacker.Installthe

cardstackerbelowthecardoutslotontheleftsideoftheprinterorthelaminator(ifused).

Card Stacker on SR200 or SR300 Printer

Whennolaminatorisused,placethestack ertabsintotheattachmentslotsonthesideofthe

printer.Besuretohangthecardstackerontheattachmentslots,notonthecardoutslot.

The card hopper can hold up to 100, 0.030 inch (0.75 mm) thick cards.

The card stacker can hold up to 100 0.030 inch (0.75mm) thick cards.

CardOutSlot

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 93 94

Keine Kommentare

DataCard LM200 Installationsanleitung Seite 20