DataCard LM200 Installationsanleitung PDF herunterladen (Seite 19)

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 11

Chapter 2: Installing the

Hardware Components

Thischapterprovidesstep‐by‐stepinstructionsforinstallingphysical

components,powercords,andcablesoftheSR200&SR300cardprinters

andoptionalLM200&LM300laminators.

Installing the Components

Usethefollowingprocedurestoconnecttheoptionallaminatortothecardprinter,andtoinstall

thecardhopperandthecardstackertotheprinterorlaminator.

Connecting the Laminator

Usetheprovidedjoiningplatetoconnectthelaminator(ifused)tothecardprinter.

1. Placetheprinteronthework

surfacewiththejoiningplate

attached.

2. Mountthelaminatoroverthe

holesonthejoiningplate.

Theinfraredportsontheprinter

andlaminatormustbealignedfor

thelaminatortowork.

Make sure to install both units on a secure, level surface. Make sure the laminator and the

printer fit securely into the joining plate holes.

Caution:Makesurethatthepowerswitchisturnedoffandthepowercordisdetached

fromthereceptaclebeforeconnectingordisconnectingthelaminator.Otherwise,

electricshock,fire,ormalfunctionoftheproductmightoccur.

JoiningPlate

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 93 94

Keine Kommentare

DataCard LM200 Installationsanleitung Seite 19