DataCard SP75 Plus Installationsanleitung PDF herunterladen (Seite 108)

Page 103

OP-01624, OP-01674 Card Jam

A card is lost in the laminator.

Possible Cause 1: A card is stuck in the laminator.

Solution 1a: Release or remove the stuck card.

Turn the Laminator Advance Knob (A) to move the card. You can turn the

knob in both directions.

Solution 1b: If it is difficult to turn the Laminator Advance Knob or you hear

clicks when you turn it, remove the laminator cartridge (B). Pull firmly to

remove the cartridge. Turn the Laminator Advance Knob (A) again to move

the card.

The laminator area is hot and remains hot for 20 minutes or more. Do not

place your hands inside the printer until the yellow label is cool.

Solution 1c: If the card will not move when you turn the Laminator Advance

Knob, power off the printer and allow it to cool down. Pull the card out.

Tips for Success:

• If cards get stuck often, run a cleaning card, change the cleaning sleeve,

and then clean the rollers in the printer.

If you cannot fix the problem, contact your service provider for assistance.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 135 136

Keine Kommentare

DataCard SP75 Plus Installationsanleitung Seite 108